NIOSH Lifting Equation Calculator (RWL & Lifting Index)
Recommended weight limit and lifting index for a two-handed lift using the Revised NIOSH Lifting Equation, with every multiplier shown so you can see what to change.
Formula
RWL = 51 lb × (10/H) × (1 − 0.0075|V − 30|) × (0.82 + 1.8/D) × (1 − 0.0032A) × FM × CM. Lifting index LI = load ÷ RWL. FM from NIOSH Table 5 (frequency, duration, V), CM from Table 7.
Worked example
Inputs: Load weight = 44 lb; Horizontal distance, hands to midpoint between ankles (H) = 23 in; Hand height at the origin (V) = 15 in; Vertical travel distance (D) = 48 in; Twist / asymmetry angle (A) = 0 °; Lifts per minute (F) = 0.2 /min; Work duration = 1 hour or less; Hand coupling (grip) = Fair.
| Recommended weight limit lb | 16 |
|---|---|
| Lifting index | 2.74 |
| Risk | LI above 1.0: increased risk of lifting-related low back pain for some workers; redesign toward LI 1.0 |
| Horizontal multiplier | 0.435 |
| Vertical multiplier | 0.888 |
| Distance multiplier | 0.857 |
| Asymmetric multiplier | 1 |
| Frequency multiplier | 1 |
| Coupling multiplier | 0.95 |
Revised NIOSH Lifting Equation (NIOSH Pub. 94-110): RWL = 51 lb × HM × VM × DM × AM × FM × CM with HM = 10/H, VM = 1 − 0.0075|V − 30|, DM = 0.82 + 1.8/D, AM = 1 − 0.0032A (inches, degrees); FM from Table 5 (linear interpolation between listed frequencies; above the maximum frequency FM = 0) and CM from Table 7. H below 10 in is set to 10; H over 25 in, V over 70 in or A over 135° make the multiplier 0. Lifting index LI = load ÷ RWL. Evaluate at the origin, and also at the destination if the worker must control the load there. Two-handed, smooth lifts only (not one-handed, seated, kneeling or shoveling).
FAQ
What is the maximum weight under the NIOSH lifting equation?
51 lb, the load constant, and only under ideal conditions: load at 10 in from the ankles, hands at 30 in, under 10 in of travel, no twisting, infrequent lifts and good handles. Every real-world factor lowers it.
What does a lifting index over 1 mean?
NIOSH: LI above 1.0 is likely to raise the risk of lifting-related low back pain for some workers; above 3.0 nearly all workers are at increased risk. Design jobs to LI 1.0 or less.
Worked example from the NIOSH manual?
A 44 lb reel lifted from V = 15 in to 63 in at H = 23 in, fair grip, once a shift. The formulas give RWL ≈ 16.0 lb at the origin (LI 2.7) and 14.3 lb at the destination (LI 3.1); the manual's worksheet shows 16.3 and 14.5 lb because it rounds each multiplier to two decimals.
Is an 80 lb bag of concrete safe to lift?
It is above the 51 lb load constant, so the lifting index is over 1.5 even in ideal posture, and roughly 2.5 to 5 when lifted from the floor, depending on how far out the hands are (H 12–20 in). Use 40 or 50 lb bags or a cart; see the sonotube bag count.
When does the equation not apply?
One-handed lifts, lifting while seated or kneeling, shoveling, high-speed lifts, unstable loads (liquids), wheelbarrows, and lifts on slippery floors. It also assumes other manual handling (carrying, pushing) is minimal.
Sources
Related
- Sling Angle Calculator (Rigging Load Angle Factor & Tension per Leg)
- Sonotube Calculator (Concrete Bags for Round Columns, Piers & Tube Forms)
- Noise Exposure Calculator (OSHA Noise Dose % & 8-Hour TWA)
More Safety calculators
- Heat Index Calculator (NWS Formula, Danger Levels & OSHA Heat Notes)
- Wind Chill Calculator (NWS Formula, °F and °C)
- 8-Hour TWA Calculator (OSHA Time-Weighted Average & Mixture Formula)
- Porta Potty Calculator for Job Sites (OSHA Toilet Requirements per Worker)
Embed this calculator
Free to embed on your site; please keep the credit link.
Last reviewed 2026-11-20.